To capture a still image
1.
Turn on the camera
by pressing the Power button. Move the Recording
Slide Switch to STOP if the camera is in video recording.
2.
After the camera power has been turned on, press the Power button to
take a photo. A short vibration and a flash of Green LED indicate the action
was successful.
✓
The still photo function is disabled during video recording.
✓
The default photo mode is “single photo”. Burst mode gives you a continuous
10 photo shots to capture that “can’t miss” moment. Time Lapse mode can be
utilized to take a series of photos at 5, 10, 30 or 60-second intervals. To change
the mode, please refer to the section “Changing the camera settings”
✓
If the card is full, the camera will vibrate for five seconds and the Green LED
will flash continuously.
www.iontheaction.co.uk EN - 31
To Next Page
