ioSafe NAS User's Guide
Based Synology on DSM 5.0
20
Reinstall IoSafe NAS
If you want to reinstall your IoSafe NAS without losing its data, you can use the RESET button on the back panel.
To reinstall IoSafe NAS:
1 Press and hold the RESET button for about 4 seconds until the IoSafe NAS emits a beep sound.
2 Within the next 10 seconds, press and hold RESET button for about 4 seconds until the IoSafe NAS emits a
beep sound.
3 Follow the installation instructions in the Quick Installation Guide for your model available at IoSafe’s Support
Section to set up the ioSafe NAS.
Important: The data saved on the IoSafe NAS will not be erased during the reinstallation. However, for security
reason, we strongly recommend that you back up the data first.
Enable SNMP Service
Go to Control Panel > Terminal & SNMP to enable SNMP service, which allows users to monitor IoSafe NAS
network flow with the network management software.
Enable Terminal Services
Go to Control Panel > Terminal & SNMP to enable Terminal service, which allows you to use Telnet or SSH to
log in to IoSafe NAS and modify its settings.
Important: Use the Terminal service with caution. Improper manipulation or modification to IoSafe NAS may result in
system malfunction or data loss.
To Next Page
Loading...