IPC CT5 - Working

EN
Working
• Press the main switch (g. 16, ref. 1).
• Press the brush button or the ECO button (g. 17, ref. 1), in addition
to activating the brush, this will also enable the vacuum function
and the ow of detergent solution.
• Lower the squeegee by operating the lever (g. 16, ref. 2).
• Depress the brush control lever (g. 16, ref. 3).
• Begin working.
! INFORMATION
This machine can dry the oor moving both forward and in reverse.
To operate the drying function in reverse, pull the lever upwards
(g. 18, ref. 1).
• When work is in progress, check the thoroughness of the wash and
regulate the ow of detergent solution accordingly, with the relative
button (g. 17, ref. 3).
! INFORMATION
Check periodically that the detergent solution is reaching the
brush, and take care to ll the tank when empty.
! WARNING
Should the red Led of the battery charge indicator light up when
work is in progress, this means that the battery is almost out of
power, and after a few seconds the brush and vacuum functions will
shut o󰀨 automatically. Proceed to recharge the battery, referring to
the section “Battery: preparation / installation / recharging”.
In cases where oors are soiled with particularly stubborn dirt, scrubbing
and drying operations can be performed in two separate stages.
Prewashing with brushes or pads:
• Plug the machine into the power socket (mains powered model).
• Raise the squeegee by operating the lever (g. 16, ref. 2).
• Press the main switch (g. 16, ref. 1).
• Press the brush control button (g. 17, ref. 1).
• Switch o󰀨 the vacuum function by pressing the suction control
button (g. 17, ref. 2).
• Depress the brush control lever (g. 16, ref. 3).
• When scrubbing particularly dirty areas, give the detergent su󰀩cient
time to perform its chemical action of detaching and suspending
the dirt in the lm of water, and allow the brushes time to exert an
e󰀨ective mechanical action.
Drying
• Lower the squeegee by operating the lever (g. 16, ref. 2).
• Press the suction control button to activate the vacuum function,
and pass over the area washed previously: this will produce an
e󰀨ect similar to a thorough scrub, with the result that subsequent
routine maintenance work on the oor will be less time-consuming.
2
1
1
2
3
1
3
Fig.16
Fig.17
Fig.18
18