User’s Guide
NOTE：
After switch or hub expand, Wireless Broadband Router can connect at most
253 client computers in LAN or WLAN.
5 LOCAL COMPUTER SETUP
Users should configure local network to access Internet by Broadband Router.
Users should know the default configuration of Broadband Router before
installation. Users must connect with Broadband Router again after configure
computer’s local network. Please make sure your computer setting is as follows,
Otherwise Broadband Router cannot be correctly connected (Linux and Mac users
please setup as follows by relative conference).
The default configuration of Broadband Router is:
— IP address：192.168.0.1
— Subnet Masks：255.255.255.0
Users can setup static or dynamic IP configuration.
5.1 SETUP UNDER WINDOWS 98/ME
(1) Install Broadband Router.
(2) Start Windows 98/ME and check LAN LED is on or off. If off, please
confirm the connection of your computer with Broadband Router.
(3) Click “start”->“Setting”->“Panel Control”.
(4) Double click the “Network and Dial-up Connection” in “control panel”.
-15- www.zioncom.net
To Next Page
Loading...
