User’s Guide
In NAT off mode, internal server setup is not available.
Internal Server Setup
This setup is needed for servers connected router's internal network.
On the WAN side, the server can be accessed through the external port
number.
On the LAN side, the server must be configured using the default application
port number.
If you want to change port number of server, use port forward.
DMZ Host Setup
The traffic route to WAN through undefined application port will be forwarded
to specified DMZ host.
The host specified as DMZ can run any server application without an internal
server setup or a port forward.
he priority of DMZ host setup is lower than the internal server or the port
forward setup.
Notes:
1. Please click “save”, when you want to keep the configuration in case power off
or reset on the router .
2.It is better to let IP address binding on or use the static IP address on the client
for user self-defined LS.
-78- www.zioncom.net
To Next Page
Loading...
