Iridium 9523 - Supported AT Commands

Iridium Communications, Inc. Information Contained in this Guide
Iridium 9523 Product Developers’ Guide is Subject to Change Without Notice
Revision 2.6
Iridium Communications, Inc. Distribution of Guide Restricted
Proprietary & Confidential Information Page 112 of 115 to Product Developers
Only
Supported AT Commands
Table 22 lists the AT commands supported by the Iridium 9523. The list of supported commands is a
subset of commands taken from Iridium’s AT Command Specification.
Table 22: Supported AT Commands
Command Description See Section
%R Display Registers 5.7.21
&Cn DCD Option 5.7.10
&Dn DTR Option 5.7.11
&Fn Restore Factory Settings 5.7.12
&Kn Flow Control 5.7.13
&Mn Asynchronous/Synchronous Mode 5.7.14
&Qn Sync/Async Mode 5.7.15
&Sn DSR Override 5.7.16
&V View Active Stored Configuration 5.7.17
&Wn Store Active Configuration 5.7.18
&Yn Designate Default Reset Profile 5.7.19
*Pn Power Phone 5.7.22
\Kn Control Break 5.7.20
+++ Escape Sequence 5.7.3
+ADJANT User Antenna Adjustment Required 5.7.112
+CAR Audio Output Control 5.7.92
+CBST Select Bearer Service Type 5.7.23
+CCFC Call Forward Service 5.7.76
+CCLK Real-Time Clock 5.7.70
+CCWA Call Waiting Service 5.7.116
+CDSI Report SMS Status 5.7.122
+CEER Extended Error Report 5.7.33
+CGMI Manufacturer Identification 5.7.24
+CGMM Model Identification 5.7.25
+CGMR Revision 5.7.26
+CGSN Serial Number 5.7.27
+CHLD Call Hold and Multiparty 5.7.120
+CHUP Hangup Call 5.7.34
+CICCID Read ICC ID From SIM 5.7.99
+CIER Indicator Event Reporting 5.7.94