Iridium 9523 - CPAS - Phone Activity Status; CR - Service Reporting Control

Iridium Communications, Inc. Information Contained in this Guide
Iridium 9523 Product Developers’ Guide is Subject to Change Without Notice
Revision 2.6
Iridium Communications, Inc. Distribution of Guide Restricted
Proprietary & Confidential Information Page 42 of 115 to Product Developers
Only
43 network subset personalization PUK required
44 service provider personalization PIN required
45 service provider personalization PUK required
46 corporate personalization PIN required
47 corporate personalization PUK required
100 unknown
Read Command: +CMEE?
Query mobile equipment error reporting level. The response is in the form:
+CMEE: <x>
Test Command: +CMEE=?
List the supported error reporting level. The response is in the form:
+CMEE: (supported <x>s)
5.7.29 +CPAS - Phone Activity Status
Exec Command: +CPAS
Query phone activity status. The response is in the form:
+CPAS: <x>
where <x> can take the following values:
0 Ready (allows commands)
1 Unavailable (does not allow commands)
2 Unknown (may not respond to commands)
3 Data Call Ringing (allows commands)
4 Data Call In Progress (allows commands)
5.7.30 +CR - Service Reporting Control
Set Command: +CR=[<mode>]
Set the service reporting level.
<mode> takes the following values:
0 Disable reporting (default)
1 Enable reporting
If reporting is enabled, the intermediate result code +CR: <serv> is returned by the Iridium 9523.
<serv> can have one of the following values:
ASYNC asynchronous transparent
SYNC synchronous transparent
REL ASYNC asynchronous non-transparent
REL SYNC synchronous non-transparent