Iridium 9523 - WFRNG - Force IRLP Renegotiation; WTM - IRLP Test Mode

Iridium Communications, Inc. Information Contained in this Guide
Iridium 9523 Product Developers’ Guide is Subject to Change Without Notice
Revision 2.6
Iridium Communications, Inc. Distribution of Guide Restricted
Proprietary & Confidential Information Page 66 of 115 to Product Developers
Only
Read Command: +WIRLP?
Query the actual IRLP parameters resulting from the negotiation (XID exchange) at the start of the most
recent data call. Note that these may differ from the desired parameters set using “+WIRLP=…”; from
power-up they are set to hardcoded defaults, and will only change as the result of the negotiation. The
response is in the form:
+WIRLP: <ver>, <k1>, <k2>, <t1>, <n2>, <t2>, <r1>, <r2>, <t4>, <mode>
Test Command: +WIRLP=?
List the supported IRLP parameter settings. The response is in the form:
+WIRLP: (supported <ver>s), (supported <k1>s), (supported <k2>s), (supported <t1>s),
(supported <n2>s), (supported <t2>s), (supported <r1>s), (supported <r2s), (supported <t4>s),
(supported <mode>s)
5.7.81 +WFRNG - Force IRLP Renegotiation
Set Command: +WFRNG=<frng>
Set forced renegotiation of IRLP parameters.
<frng> can take the following values:
0 Do not renegotiate (default)
1 Renegotiate
2 Disconnect
Read Command: +WFRNG?
Query the current parameter setting. The response is in the form:
+WFRNG: <frng>
Test Command: +WFRNG=?
List the supported parameter settings. The response is in the form:
+WFRNG: (supported <frng>s)
5.7.82 +WTM - IRLP Test Mode
Set Command: +WTM=<tm>
Select DCE mode of operation.
<tm> can take the following values:
0 IRLP test mode off (default)
1 IRLP test mode on
Read Command: +WTM?
Query the current parameter setting. The response is in the form:
+WTM: <tm>
Test Command: +WTM=?
List the supported parameter settings. The response is in the form:
+WTM: (supported <tm>s)