Iridium 9523 - Kn - Control Break; R - Display Registers; Pn - Power Phone; CBST - Select Bearer Service Type

Iridium Communications, Inc. Information Contained in this Guide
Iridium 9523 Product Developers’ Guide is Subject to Change Without Notice
Revision 2.6
Iridium Communications, Inc. Distribution of Guide Restricted
Proprietary & Confidential Information Page 39 of 115 to Product Developers
Only
0 Select profile 0 (default)
1 Select profile 1
5.7.20 \Kn - Control Break
Control the response of the Iridium 9523 to a break received from the FA or the remote modem according
to the parameter specified. The response is different in three separate states:
When a break is received from FA when Iridium 9523 is in data transfer mode:
0 Enter in-call command mode, no break sent to remote modem
1 Clear data buffers and send break to remote modem
2 Same as 0
3 Send break to remote modem immediately
4 Same as 0
5 Send break to remote modem in sequence with transmitted data (default)
When a break is received from the remote modem during a non-error corrected connection:
0 Clear data buffers and send break to FA
1 Same as 0
2 Send break to FA immediately
3 Same as 2
4 Send break to FA in sequence with received data
5 Same as 4 (default)
5.7.21 %R - Display Registers
Display all the S registers in the system.
5.7.22 *Pn - Power Phone
Turn Iridium 9523 off.
0 Turn phone OFF
5.7.23 +CBST - Select Bearer Service Type
Set Command: +CBST=[<speed>[,<name>[,<ce>]]]
Select the bearer service type for mobile originated calls.
<speed> can have the following values:
0 Autobauding
1 300 bps V.21
2 1200 bps V.22
4 2400 bps V.22bis
6 4800 bps V.32
7 9600 bps V.32 (default)