Iridium 9523 - Iridium Specific S-Register Extensions

Iridium Communications, Inc. Information Contained in this Guide
Iridium 9523 Product Developers’ Guide is Subject to Change Without Notice
Revision 2.6
Iridium Communications, Inc. Distribution of Guide Restricted
Proprietary & Confidential Information Page 100 of 115 to Product Developers
Only
Register
Number
Range Default Description
Sr=n Command
Write Protected
in SAC0201
S95 0-255 0 Bitmap register for extended result codes (overrides
Wn setting).
0 = CONNECT shows DCE speed
2 = Enable CARRIER XXXX
3 = Enable PROTOCOL: XXXX
5 = Enable COMPRESSION: XXXX
6.3 Iridium Specific S-Register Extensions
Table 17: Iridium-Specific S-Registers
Register
Number
Range Default Description
Sr=n Command
Write Protected
in SAC0201
S13 0-255 0 Bitmap register where bits 0-1 reflect the DCE data
bits, bits 2-3 reflect the DCE stop bits, bits 4-6 reflect
the DCE parity settings, and bit 7 is not used
Yes
S15 0-2 0 Auto-answer mode selection
Bits 0-1: 0 (auto-answer voice and data calls)
1 (auto-answer voice calls only)
2 (auto-answer data calls only)
S34 0-255 0 Bitmap register where bit 7 reflects the +DR setting,
bits 0-1 reflect the data compression type (PT), bit 6
reflects the +DS compression negotiation setting.
Yes
S35 0-255 5 Bearer service capabilities
S42 0-255 0 GSM Call clearing code as returned by the network.
Refer to GSM 04.08 [7] Table 10.86 Cause Information
Element Values.
Yes
S43 0-255 32 Bitmap register:
0 = +CMGF setting
1 = +CBST parameter <name> setting
2 = +CMEE setting
3 = +CMEE setting
Yes