CHAPTER 4 - BASIC SETTINGS
37
Warning:
If you choose Barcodes a secondary scan type, the reading results may be
less accurate than if you choose Barcodes as primary scan type. If possible,
scan thus your barcodes separately and choose Barcodes in the Scan type
field.
Dot matrix
The option Dot matrix is used to make the pen read dot matrix
symbols, i.e. symbols that are made of isolated, separated dots.
Select this option if you intend to read so-called "draft" or "9 pin"
dot matrix text.
Also refer to: Learn how to... Read dot matrix text.
Small print
The option Small print is used to get optimized results when
reading small printed text. Select this option if you want to read text
with a font size smaller than 10 points.
Also refer to: Learn how to... Read small print.
TARGET
You may choose the way the read data is being inserted in the target
application: either via the clipboard, or directly in the application,
without having to operate manually (see below).
Tip:
The formatting that is active in the target application will apply to the data
which is being inserted in the application: if you have selected, say, Palatino
12 point bold in the application, the text will be inserted in Palatino 12 point
bold, whatever the original font or size may have been.
To Next Page
Loading...
Need help?
General
