CHAPTER 5 - FREQUENT COMMANDS
43
then enter your keyboard commands or characters in the
proposed field and click OK to confirm.
Switch scan type: This allows you to program the switch to the
next scan type in the list of scan types available (see: Basic
settings, Reading options, Scan type).
If the current scan type is Text, this will make you switch to
Numeric. If the current scan type is Numeric, this will make
you switch to the Black-and-White image. (Remember that the
reading mode is always specified in the Status window).
Enable dot matrix mode: This is used to enable the dot matrix
reading mode.
Undo last scan: This is used to remove the last scan that was
inserted in the target application.
• Click OK to confirm and close the window.
DELIMITERS
With the delimiters, you can indicate how the scanned lines must be
delimited for the reading. Where should the reading actually start if
a word has been cropped during scanning? How should hyphens be
interpreted when occurring at the end of a line? Should keyboard
commands or characters be added before and/or after the read line?
To Next Page
Loading...
Need help?
General
