IT
EN
MASTER
196
COMPRESSORE
Il compressore è un accessorio espressamente stu-
diato per svuotare completamente il tubo di polietilene
dall’acqua a ne irrigazione. Questa operazione faci-
lita notevolmente lo spostamento ed il trasporto della
macchina e risulta pressoché indispensabile nel caso
di semoventi omologate per la circolazione su strada,
dove è obbligatorio rispettare i pesi massimi indicati.
FUNZIONAMENTO DEL COMPRESSORE
• Mettere in azione il compressore, al minimo, la-
sciando aperto il rubinetto (A) in modo da poter
accelerare il motore: durante questa operazione,
assicurarsi del corretto funzionamento dell’oliatore
(come illustrato in seguito).
• Portare la presa di forza del trattore a 540 g/min.
• Chiudere il rubinetto (A) e contemporaneamente
aprire la saracinesca (B).
• Effettuato lo svuotamento, nel limite massimo di 4
minuti, portare il motore al minimo, aprire il rubinet-
to (A), contemporaneamente chiudere la saracine-
sca (B), dopodiché fermare la presa di forza.
-
-
GNERE IMMEDIATAMENTE IL COM-
A
B
COMPRESSOR
The compressor is an accessory that is expressly
designed to completely empty the polyethylene
hose of water at the end of irrigation. This operation
signicantly facilitates movement and transport of the
machine and is practically indispensable for irrigators
certied for road trafc where the maximum weights
indicated must be followed.
COMPRESSOR OPERATION
• Start the compressor at the minimum, leaving the
tap (A) open in order to be able to accelerate the
engine. During this operation, check the proper
operation of the lubricator (as shown below).
• Bring the tractor PTO to 540 g/min.
• Close the tap (A) and at the same time open the
gate valve (B).
• Empty, within the maximum limit of 4 minutes, set
the motor to the minimum, open the tap (A) and
close the gate valve (B) at the same time, then
close the PTO.
-
-
DOWN THE COMPRESSOR to avoid
Manuale d’uso e manutenzione
IRRIGATORI SEMOVENTI
Operating and service manual
HOSE REEL IRRIGATORS
Mode d’emploi et d’entretien
ENROULEURS
Manual de uso y mantenimiento
ENROLLADORES