ISHIDA IGB Series - Page 16

2.1 Presetting the Values
IGX/IGB Series Operation Manual No. 0202A page 13
2
PRESET FUNCTION
10
Increase or decrease the numeric value by pressing the ZERO (+) or TARE (-) key. Then,
press the COLUMN key to determine the value. Repeat this step until completing the entry.
[Example] Lower limit value 500g
or
Ä Ä
IGX Series
IGB Series
Setting Values for Other PLUs
11
Press the SET key to determine the lower limit value.
Repeat steps 3 through 10 above for setting the values for other PLUs.
NOTE If the upper limit value has already been preset, only a value equal to or less than this
limit value can be set.
Finishing the Setting Procedures
Press the COLUMN key to finish the setting procedure.
IGX Series IGB Series
12
Ä