6A–74 ENGINE MECHANICAL
3. After pressing in the slinger, make sure that the
distance between crankshaft end surface and the
slinger is A as specified.
Distance (A) : 16.7 - 17.3mm (0.657 - 0.681 in)
NOTE : Be sure to replace the slinger and oil seal as a
set.
5. Use the oil seal installer 894396-8560 to install the
oil seal.
1. Apply engine oil to the oil seal lip.
Do not allow engine oil to come in contact with the
outside oil seal and felt ring.
2. Insert the oil seal (1) into the adapter (2) .
3. Insert the oil seal sleeve (3) to the adapter.
4. Tighten the center bolt until the sleeve comes into
contact with the adapter stopper.
5. After pressing the oil seal, make sure that the
distance between crankshaft end surface and the
oil seal is B as specified.
Distance (B) : 7.35 - 7.65 mm(0.289 - 0.301 in)
6. Install the flywheel and washer to the crankshaft.
1. Block the crankshaft with a piece of hard wood to
prevent the flywheel from turning .
020EY00023
To Next Page
Loading...
