ITC DOSTEC AC - Page 13

13
0001 :
0001
Q = 025 %
M = 005 pulses
PROPORTIONAL X:Y
0001
0001
:
PROPORTIONAL X:Y
Q = 025 %
M = pulses005
0001
0001
:
Q = %
M = 005 pulses
025
PROPORTIONAL X:Y
l / h
60.0
l
%
2 5
3 6
PROPORT. %
Set Point 000,05
Stop Pump OFF
PROPORT. %
Set Point 000,05
Stop Pump OFF
12 150
l / h
30
m3/h
l
%
6 2
8 9
ENT
ENT
Conguration
Select the number of pump cycles
Change by pressing
and conrm by pressing
ENT
Select pump speed in %
Change by pressing and conrm by pressing
ENT
For Y=1 Q must be set at less than 50%
Select the maximum number of pulses in memory
Change by pressing
and conrm by pressing
ENT
ENT
Start/stop the pump
The pump will start if the Remote Activation input is activated.
4.1.2.2 %/ppm Flowmeter
By entering a proportion value (%/ppm) and with a pulse input from a owmeter, the pump will regulate its
speed to dose the ow according to the desired proportion.
Instantaneous water ow rate.
Pressing will cause the ON/OFF indicator to toggle to ON
and the pump will start if the Remote Activation input is
activated
* For the conguration of units (%/ppm) see Units in the Conguration section
* For owmeter conguration. See the Conguration/Setup section
Proportionality value in % or ppm
Change by pressing
and conrm by pressing
ENT
Select OFF to perform proportional dosing with no volume
limit.
Change by pressing and conrm by pressing
ENT