ITech CalPower IT6302

Output Commands
Copyright© Itech Electronics Co., Ltd. 20
Chapter5 Output Commands
OUTPut[:STATe][:ALL]
This command is used to control the output switch state.
Command syntax
OUTPut [:STATe] <bool>
Arguments
0|1|ON|OFF
*RST Value
OFF
Query syntax
OUTPut:STATe[:ALL]?
Returns
0|1
OUTPut:SERies[:STATe]
This command can set the serial state of CH1+CH2.
Command syntax
OUTPut:SERies[:STATe]
Arguments
0|1|ON|OFF
Query syntax
OUTPut:SERies[:STATe]?
OUTPut:PARAllel[:STATe]
This command can set the parallel state of CH1+CH2.
Command syntax
OUTPut:PARallel [:STATe]
Arguments
0|1|ON|OFF
Query syntax
OUTPut:PARAllel[:STATe]?