ITech CalPower IT6302

Voltage Setting Commands
Copyright© Itech Electronics Co., Ltd. 26
Command syntax
[SOURce:] VOLTage [:LEVel]:DOWN[:IMMediate][:AMPLitude]
Arguments
None
Related Command
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
[SOURce:]VOLTage[:LEVel][:IMMediate]:STEP[:INCRe
ment]
This command is used to set the voltage step.
Command syntax
[SOURce:] VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
Arguments
Voltage value
Unit
kV|V|mV|uV
Query syntax
[SOURce:] VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]?
[SOURce:]VOLTage:LEVel]:TRIGgered[:IMMediate][:IN
CRement]
This command is used to set the trigger voltage.
Command syntax
[SOURce:] VOLTage[:LEVel]:TRIGgered[:IMMediate][:INCRement]
Arguments
Voltage value|Min|Max|Def|Up|Down
Unit
kV|V|mV|uV
Query syntax
[SOURce:] VOLTage[:LEVel]:TRIGgered[:IMMediate][:INCRement]?
[SOURce:]VOLTage:LIMIT[:LEVel]
This command is used to set the upper limited voltage.