ITech IT6522D - SCPI Status Registers; Status Register Bit Definitions

Quick Start
Copyright ©ITECH Electronics Co., Ltd. 14
2.5 Rear Panel Introduction
Different models of IT6500D Series power supply have different rear panels.
The 2U rear panel is as shown below. Other models have same rear panels as
2U Model except systembus ans AC input terminal.
IT6512D/IT6513D/IT6514D/IT6515D/IT6516D/IT6517D/IT6522D/IT6523D/IT6524D/
IT6525D/IT6526D/IT6527D
1 GPIB interface
2 RS232 interface
3 LAN interface
4 USB interface
5 Fan
6 Not for user
7 Earth ( ground) terminal
8 AC power input terminals
9 Not for user
10 Not for user
11 The positive terminal of output
12 Sense terminals
13 The negative terminal of output
14 System bus
15
Analog interface and CAN
interface
2.6 Power-on Selftest
A successful selftest indicates that the purchased power product meets delivery
standards and is available for normal usage.
Before operation, please confirm that you have fully understood the safety
instructions.
 To avoid burning out, be sure to confirm that power voltage matches
with supply voltage.
 Be sure to connect the main power socket to the power outlet of
protective grounding. Do not use terminal board without protective
grounding. Before operation, be sure that the power supply is well
grounded.
 To avoid burning out, pay attention to marks of positive and negative
polarities before wiring.
Power Switch Introduction
User can press the power switch of IT6500D series power supply directly to turn
on or turn off the instrument.
The status of Powe switch are as follows.
ＯＦＦ ＯＮ
ＯＮ ＯＦＦ