ITech IT6522D - Page 26

Function and Features
Copyright ©ITECH Electronics Co., Ltd. 19
Info: The information of LAN.
LAN Status: Down
IP Mode: Disconnect
IP Addr: 0.0.0.0
SubNet: 0.0.0.0
Gateway: 0.0.0.0
DNS1: 0.0.0.0
DNS2: 0.0.0.0
MAC: 8C:C8:F4:40:01:E1
MDNS Status:
HostName:
HostDesc:
Domain:
TCPIP::INSTR:
Socket Port: 30000
Config:
IP-Mode: Auto/Manual
Server-Config:
MDNS: On/Off
PING: On/Off
telnet-scpi: On/Off
Web: On/Off
VX-11: On/Off
Raw-socket: On/Off
Restore: Restore to factory defaults
Reset: Save all of setting, and the settings
take effect after restart.
CAN
Select CAN communication interface
250K:
Baud rate
Addr: address of power supply
Prescaler: Prescaler
BS1 Value: Not settable
BS2 Value:
Not settable
ReturnMeter
Enables automatic delay to switch display from setting
to measured value ( meter).
Off( Def)
Auto return Meter function disabled.
On
Auto return Meter function enabled
P-Out
Power whether power supply was on
Off( Def)
After power on,the instrument will be in
the off state.
Last
If output was on prior to turning the
power off,the ON state will be resumed
after power on.
CONFIG
Config menu
Load-Status
Setting the internal load status.
Off( Def)
Disables the dummy load ( default).
On
Enables the dummy load.
Static-Curr setting the static current when output is Off status
Off
Turn off static current function (avoid current
flow-backward)