ITech IT8514C+ - 3.10 Test Function; 3.10.1 Transient Test Function

Input Settings
Copyright © ITECH Electronic Co., Ltd. 30
Query Syntax
[SOURce:]POWer:PROTection[:LEVel]?
Returned Parameters
<NR2>
[SOURce:]POWer:PROTection[:LEVel]?
This command is used to query the power protection level.
Command Syntax
[SOURce:]POWer:PROTection[:LEVel]?
Unit
W
*RST Value
MAXimum(high range)
[SOURce:]VOLTage:[LEVel:]ON <NRf+>
This command sets the voltage of sink current on.
Command Syntax
[SOURce:]VOLTage[:LEVel]:ON <NRf+>
Parameters
None
Unit
V
*RST Value
1
Examples
VOLT:ON 3
Query Syntax
[SOURce:]VOLTage[:LEVel]:ON?
Returned Parameters
<NR2
[SOURce:]Voltage:[LEVel:]ON?
This command is used to query the voltage of sink current on.