ITech IT8514C+

Measure Commands
Copyright © ITECH Electronic Co., Ltd. 45
Examples
MEAS:VOLT:MIN?
Returned Parameters
<NR2>
MEASure[:SCALar]:VOLTage:PTPeak?
This command is used to query the voltage peak-to-peak value.
Command Syntax
MEASure[:SCALar]:VOLTage:PTPeak?
Parameters
None
Examples
MEAS:VOLT:PTP?
Returned Parameters
<NR2>
MEASure[:SCALar]:CURRent[:DC]?
This command is used to query the current average of the electronic load.
Command Syntax
MEASure [:SCALar]:CURRent[:DC]?
Parameters
None
Examples
MEAS:CURR?
Returned Parameters
<NR2>
MEASure[:SCALar]:CURRent:MAXimum?
This command is used to query the peak current of the electronic load.
Command Syntax
MEASure[:SCALar]:CURRent:MAXimum?
Parameters
None