ITech IT8514C+

Input Settings
Copyright © ITECH Electronic Co., Ltd. 31
Command Syntax
[SOURce:]VOLTage[:LEVel]:ON?
Unit
V
*RST Value
1
[SOURce:]Voltage:[LEVel:]OFF <NRf+>
This command is used to set the load start unloading voltage value.
Command Syntax
[SOURce:]VOLTage[:LEVel]:OFF <NRf+>
Parameters
MIN ~ MAX | MINimum | MAXimum
Unit
V
*RST Value
0.5
Examples
VOLT:OFF 2
Query Syntax
[SOURce:]VOLTage[:LEVel]:OFF?
Returned Parameters
<NR2>
[SOURce:]Voltage:[LEVel:]OFF?
This command is used to query the load start unloading voltage value.
Command Syntax
[SOURce:]VOLTage[:LEVel]:OFF?
Unit
V
*RST Value
0.5