ITech IT8514C+

OCP Testing Commands
Copyright © ITECH Electronic Co., Ltd. 50
Command Syntax
OCP:IEND?
Parameters
None
Unit
A
OCP:STEP
This command is used to set the current step of OCP test.
Command Syntax
OCP:STEP<NR1>
Parameters
1~1000
Examples
OCP:STEP 500
Query Syntax
OCP:STEP?
Returned Parameters
<NR2>
OCP:STEP?
This command is used to query the current step of OCP test.
Command Syntax
OCP:STEP?
Parameters
None
OCP:DWELl <NRf+>
This command is used to set the single-step dwell time of OCP test.
Command Syntax
OCP:DWELl <NRf+>
Parameters
0.00001~0.99999