ITech IT8600 Series

Measurement Commands
Copyright © Itech Electronic Co., Ltd. 13
MEASure:POWer:PFACtor?
FETCh:POWer:PFACtor?
This command is used to read the power factor of electronic load.
Command syntax:
MEASure[:SCALar]:POWer:PFACtor?
FETCh[:SCALar]:POWer:PFACtor?
Returned value:
<NR3>
MEASure:POWer:REACtive?
FETCh:POWer:REACtive?
This command is used to read the reactive power of VAR as the unit.
Command syntax:
MEASure[:SCALar]:POWer:REACtive?
FETCh[:SCALar]:POWer:REACtive?
Returned value:
<NR3>
MEASure:RESistance?
FETCh:RESistance?
This command is used to read the resistance value of ohm as the unit.
Command syntax:
MEASure[:SCALar]:RESistance?
FETCh[:SCALar]:RESistance?
Returned value:
<NR3>