ITech IT8600 Series

Load Commands
Copyright © Itech Electronic Co., Ltd. 36
WAVE:STOP
This command can stop the waveform capture.
Command syntax:
WAVE:STOP
Parameter:
None
Query Syntax:
None
WAVE:SINGle
This command is used to trigger a single waveform capture.
Command syntax:
WAVE:SINGLe
Parameter:
None
Query Syntax:
None
WAVE:VOLTage:DATA?
This command is used to obtain the voltage data after normalization.
Command syntax:
WAVE:VOLTage:DATA?
Parameter:
<n>
Query Syntax:
WAVE:VOLTage:DATA?
Returned value:
NR1，NR1…NRf，NRf