ITech IT8600 Series

Measurement Commands
Copyright © Itech Electronic Co., Ltd. 17
Command syntax:
MEASure:VOLTage:HARMonic[:AMPLitude]? <FUNDamental|TOTal|ALL or
NR1>
Parameter:
FUNDamental| TOTal | ALL or NR1
Returned value:
<NR3>
MEASure:PHASe:HARMonic?
This command is used to read all the phase of harmonic measurement.
Command syntax:
MEASure:PHASe:HARMonic? <ALL or NR1>
Parameter:
ALL or NR1
Returned value:
<NR3>
MEASure:VOLTage:HARMonic:DISTort?
This command is used to read the percentage of each harmonic.
Command syntax:
MEASure:VOLTage:HARMONIC:DISTort? <TOTAL|ALL|NR1>
Parameter:
TOTal|ALL or NR1
Returned value:
<NR3>
FETCh:VOLTage:HARMonic?
This command is used to read all the harmonic data.
Command syntax:
FETCh:VOLTage:HARMONIC[:AMPLitude]? <FUNDamental|TOTal|ALL or
NR1>