ITech IT8600 Series

Load Commands
Copyright © Itech Electronic Co., Ltd. 28
Parameter:
0|1|OFF|ON
Reset value:
0|1
Query Syntax:
[SOURce:]POWer:PROTection:STATe?
Returned value:
0|1
RESistance
This command is used to set the resistance of electronic load.
Command syntax:
[SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude] <NRf+>
Parameter:
MINimum|MAXimum|DEFault or NRf
Unit:
Ohm
Reset value:
MAXimum
Query Syntax:
[SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude]？
[MINimum|MAXimum]
Returned value:
<NR3>
VOLTage
This command is used to set the voltage level of electronic load.
Command syntax:
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRF+>