Common Commands
Copyright © Itech Electronic Co., Ltd. 62
Relevant Command
*ESE *ESR? *PSC *STB?
*STB
This command can query the Status Byte register. After executing this
command, the bit6 of status byte register will be reset to 0.
Bit Position 6 5 4 3
Condition RQS ESB MAV QUES
The descriptions of Parameter in the table are as follows:
RQS: request for service
ESB: Event summary bit
MAV: Message available
QUES: One or more questionable event register is reset
Query Syntax
*STB?
Parameter
None
Returned value
<NR1>
Relevant Command
*CLS *ESE *ESR
*SAV
This command stores the present state of the electronic load to a specified
location in memory. These parameters including current settings, voltage
settings, operation mode and so on.
Command syntax
*SAV <NRf>
Parameter
0~9
To Next Page
Loading...
Need help?
General
