Load Commands
Copyright © Itech Electronic Co., Ltd. 30
Parameter:
MINimum|MAXimum|DEFault or NRf
Unit:
None
Reset value:
MAXimum
Query Syntax:
[SOURce:]PFACtor[:LEVel][:IMMediate][:AMPLitude]? [MINimum|MAXimum]
Returned value:
NR3
INPut:TIMer
This command is used to set the timer mode.
Command syntax:
[SOURce:]INPut:TIMer[:STATe] <bool>
Parameter:
0|1|OFF|ON
Reset value:
0
Query Syntax:
[SOURce:]INPut:TIMer[:STATe]?
Returned value:
0|1
INPut:TIMer:DELay
This command is used to set the delay time of timer.
Command syntax:
[SOURce:]INPut:TIMer:DELay <NRf+>
Parameter:
MINimum|MAXimum|DEFault or NRf
To Next Page
Loading...
