Settings
6 720 802 419 (2012/06) en
56
16.3 Holiday
During holidays (absence), the heating can, for example, be kept at a
lower or higher level and hot water production can be switched off. Start
and Stop date, Room temperature and Block hot water production are
only displayed if the holiday function is activated.
> Circuit 1 and hot water
>> Activate holiday function
>> Start date
>> Stop date
B Set start and stop date for the desired period. Format yyyy-mm-dd.
The period starts and ends at 00:00. Both the start and end date are
included in the period.
B Terminate the period prematurely by indicating No in the menu
Activate holiday function.
>> Room temperature
B Set the room temperature that should apply to the circuit during the
period.
>> Copy to all heating circuits
>> Block hot water production
> Circuit 2, 3... (optional)
>> Activate holiday function
>> Start date
>> Stop date
>> Room temperature
B Set the values in the same way as for Circuit 1 and hot water.
16.4 Energy measurements
> Generated energy
This displays Generated energy in kWh divided into Heating and Hot
water.
> Consumption electric additional heat
This displays Consumption electric additional heat in kW h divided into
Heating and Hot water.
Factory setting No
Alternative No/Yes
Table 95 Holiday function
Factory setting 17 °C
Lowest value 10 °C
Highest value 35 °C
Table 96 Room temperature, holiday
Factory setting No
Alternative Yes/No
Table 97 Copy circuits
Factory setting No
Alternative Yes/No
Table 98 Block hot water
Energy is measured per compressor; the calculated
results are added prior to being displayed.
To Next Page
Loading...