J-TECH JTECH-4K88-EX-RX - Ir Remote Control

IR REMOTE
Connect an IR receiver to the IR EYE port of the Matrix Switcher, users can control it
through the included IR remote. Here is a brief introduction to the IR remote.
① Standby button:
Press it to enter/ exit standby mode.
② INPUTS:
Input channel selection buttons, range from 1~8.
③ OUTPUTS:
Output channel selection buttons, range from 1~8.
④ Menu buttons:
 ALL: Select all outputs.
 EDID management button: Enable input port to
manually capture and learn the EDID data of output
devices.
 CLEAR: Withdraw an operation like switching output
channel, learning EDID data before it comes into
effect. Meanwhile, the matrix will return to the
previous status.
 ENTER: Confirm operation.
INPUTS
OUTPUTS
MENU
1 2
3
4
5
6
7 8
1 2
3
4
5
6
7 8
ALL EDID
CLEAR ENTER
1
2
3
4
IR REMOTE CONTROL
7