J-TECH JTECH-4K88-EX-RX - IR Pass-Through Control; Controlling Remote Displays; Controlling Local Sources

By using IR pass-through & HDBaseT transmission technology, the 4K HDBaseT
Matrix Switcher has some functions as follows:
 Control far-end display.
 Control local source device.
Control far-end display
Connect an IR receiver with IR carrier to the IR IN port of the Matrix Switcher; users
can control far-end output displayer via its IR remote from local. In that case, the IR
signal is transferred via twisted pair. Only the corresponding IR OUT port can emit
control signals to the remote display.
See the figure below:
Note: The IR receiver connected to IR IN must be with IR carrier
DVD
IR Remote
HDTV
IR Emitter
Receiver
HDTV
IR IN IR OUTHDMI OUT
TP IN
LINK HDCP
INPUTS OUTPUTS
IR IN
IR OUT
CONTROL
AUDIO OUTPUT
1 1 2 3 4 5 6 7 8 ALL2 3 4 5 6 7
IR EYE
1 2
3 4
5
6 7 8
1-HDBT
3-HDBT 4-HDBT 5-HDBT 6-HDBT 7-HDBT 8-HDMI
Tx Rx
RS232 8-SPDIF L R8TCP/IP
IR PASS-THROUGH CONTROL
8