Multiple to Multiple: (IR Matrix):
The 8 “IR OUT” ports and the 7 “IR IN” ports on the far-end receivers make up a 7 x
8 IR matrix. See as below:
The IR signal is sent by IR remote, then it is transferred to HDBaseT receiver, then
to corresponding zone of the matrix through the twisted pair, finally it is transferred to
IR OUT port and received by controlled device.
Switching Operation:
Sending command:[x1]R[x2].
x1: Corresponding to the 8 IR OUT ports of the Matrix Switcher, the IR transmitter
connected to this port can be placed at IR receiving area of output device or the
Matrix Switcher itself.
x2: Corresponding to the zone (receive IR signal from HDBaseT receiver with IR
IN port connects with IR receiver) number of the Matrix Switcher.
→ Example: Send command “3R2.” to transfer IR signal received from zone 2 to IR
OUT port 3.
IR Emitter
DVD
1 2 3 4 5 6 7 8
HDTV
Receiver 1
HDTV
IR IN IR OUTHDMI OUT
TP IN
LINK H DCP
Receiver 2
HDTV
IR IN IR OUTHDMI OUT
TP IN
LINK H DCP
Receiver 3
HDTV
IR IN IR OUTHDMI OUT
TP IN
LINK H DCP
INPUTS OUTPUTS
IR IN
IR OUT
CONTROL
AUDIO OUTPUT
1 1 2 3 4 5 6 7 8 ALL2 3 4 5 6 7 IR EYE
1 2
3 4 5 6 7 8
1-HDB T
3-HDB T 4-HDBT 5 -HDBT 6 -HDBT 7 -HDBT 8-HDMI
Tx Rx
RS232 8-S PDIF L R8TCP/IP
To Next Page
Loading...