Controlled by PC(s) in LAN
Connect the Matrix Switcher, a router and several PCs to setup a LAN (as shown in
the following figure). Set the network segment of the Matrix Switcher to the same as
the router’s, then PCs within the LAN are able to control the Matrix Switcher.
Follow the below steps to connect the devices:
Step1. Connect the TCP/IP port of the Matrix Switcher to Ethernet port of PC with
twisted pair.
Step2. Set the PC’s network segment to the same as the Matrix Switcher’s. Do
please remember the PC’s original network segment.
Step3. Set the Matrix Switcher’s network segment to the same as the router.
Step4. Set the PC’s network segment to the original ones.
Step5. Connect the Matrix Switcher and PC(s) to the router. PC(s) within the LAN is
able to control the Matrix Switcher asynchronously.
Then it’s able to control the device via GUI.
To Next Page
Loading...