J2 225 System Manual
Version 1.0 May 29, 2012
Assembly
First attach the four mounting clips using the 3 mm screws, as shown below:
Next attach the mounting bracket to the wall or other surface using at least four of the
bracket mounting holes. Please note that the bracket has both a 100mm and 75mm hole
pattern, so that the bracket can be used with the VESA bracket as well as being directly
mounted to a wall. Be sure to use a mounting screw with sufficient hold force for the
material being mounted to and allow for the stress of the adjustment of the swing arm
base.
To Next Page
Loading...
