Jackle ProPuls 320 Compact - Technical Specifications; Technical Data: Power Source and Wire Feed

ProPuls 320C
Operating manual Page 35
14. Technical data
Power source ProPuls 320C
Supply voltage, 50/60 Hz 400V
3 Phase
Fuse 16 A slow
Max. power draw 18,8 kVA
Cos phi 0,9
Set-point range Step less 10 - 320 A
Operating voltage 15 – 30 V
Open circuit voltage 63 V
Duty cycle 40 % (40 °C) 320 A / 30 V
Duty cycle 60 % (40 °C) 270 A / 27,5 V
Duty cycle 100 % (40 °C) 240 A / 26 V
System of protection IP 23
Insulation class H
System of cooling F
Weight complete 96 kg
Dimensions L x W x H (mm) 720x350x530 (solo), 720x350x830 (FB10), 1030x540x1000 (KG10)
Wire feed rate
0,5 – 22 m/min
Diameter of wire
0,8 – 1,2mm
Wire feed motor with
four-roller drive system
50W / 24V DC
S
Authorised for welding under increased electrical hazard
Manufactured in accordance with European Standards
EN 60 974-1 and EN 60 974-10
Generator operation:
The generator must have 30% more power as the welding unit.
Example: 19kVA (unit) + 30% = 25kVA. The generator for this unit must have 25kVA.
A generator with less power will damage the Jäckle welding unit as well as the generator himself
and is disallowed.