33
ATTENTION
- Mount all ballasts recommended by the tractor manufacturer before starting to
work with the Falcon Vortex sprayer.
- Before cutting the PTO shaft tubes, check for all possibilities of movement of
the sprayer on the lift arms and third point.
- Make sure the hitch pins locks are correctly installed.
- For instructions in detail, please refer to the section MAINTENANCE - PTO
SHAFT.
CONNECTING THE PTO
drawbar
- Mount the sprayer on the tractor's three-
point suspension and level it as shown in
the figure beside.
h h
± 1.96 in ± 1.96 in
NOTE: Align the forks as shown by "A".
A
height
adjustment
- Adjust the tractor hydraulic lift lever so
that the sprayer is not raised too high.
- Remove or set aside the tractor's drawbar.
- Adjust the PTO shaft. If necessary, cut
the male and female tubes so that, after
connecting the sprayer, it has the overlaps
recommended in the figure beside.
To Next Page
Loading...
Need help?
General
