2) ● key Decimal point; toggles between upper limit and lower limit setting when HI-LO-OK
function is enabled. (See 7-2-1)
1) PRINT key Outputs data when Prt.Pr (print stably) is selected as the print mode.
2) ZERO key Zeros the display (within 2% of max.capacity) or cancels Tare action.
3) TARE key Inputs the weight of the object on the weighing pan as a Tare value; inputs
the indicated value entered via the numeric keys as a pre-set Tare value; cancel tare
action.
4) CE key Clears the indicated input values.
5) MC/CK key Short press deletes accumulation records; long press to initial Upper &
Lower Quantity Limit setting.
6) MR key Recalls and displays the total Accumulation data (weight, total count and
number of weightments ) and the first 10 records in details.
7) UWS key Inputs the indicated unit weight value entered via numeric keys
8) M+ key Adds the indicated weight or piece count value into Accumulation memory.
9) SMPL key Short press enters the sampling mode.
4-3 Power Supply
Power supply
Please verify the local AC power source and switch the two-stage switch to the proper place
before plugging into the power outlet.
Alternative power supply
1) AC 110V/220V (AC±10%)
2) (6V/4A) internal rechargeable battery
Power Consumption
About 300mW (without backlight)
About 380 mW (with backlight)
Low battery warning
When ― ‖ appears in the upper left corner of the weight window, the battery power
requires recharging. The charge lamp turns green from red when the recharging is completed
(which takes about 8 hours). Disconnect the scale from power supply when it is fully charged.
A full charged battery can operate the scale for approximately 65 hrs with backlight, 80hrs
without backlight.
Note: Battery is to replaced only by an authorized service dealer .Risk of explosion can occur
if replaced with the wrong type or connected improperly
To Next Page
Loading...
Need help?
General
