5. Operation
Here we take JCL-15k model as an example.
5-1 Basic Weighing
5-1-1 Weighing
Place item to be weighed on the scale. The weight
window shown is 2000g, Gross Weight.
5-1-2 Tare & Preset Tare
Tare
When weighing a sample that must be held in a container, taring stores the container weight
into memory.
1) Under the weighing mode, place the container
on the scale, weight window shown is 500g.
Press the key TARE to complete tare action.
The symbol appears and with Symbol ― ‖
pointing at ―NET”.
2）To clear tare, with an empty pan, Press down
the key TARE or key ZERO.
Preset Tare
1) Under the unload condition , Enter tare
value using the numeric keys together with
key ●, then press key TARE. The weight
window displays the tare value.
2) Put the load on the container, the scale will automatically deduct the value of the container
from the total value.
Note: during the process of Tare or Preset Tare, if the load and container are not removed,
press key zero to check the gross weight.
5-1-3 Unit Switch Operation
1) Press key SMPL while powering on the scale.
2) Key in 1132 via numeric keys.
3) Again press key SMPL to enter unit Selection
mode. Numeric key 1 is to toggle between g (kg) and
Lb units.
To Next Page
Loading...
Need help?
General
