7. Setting Mode
1) Turn on the power while pressing key
ZERO and setting mode starts.
Note: The following Steps (2) ~ (11) do not require to operate in order.
3) Press numeric key 0 to shift backlight
modes. Options are On, OFF and OnOFF.
=Auto-on with items greater than 9 divisions
placed on the pan.
= No backlight
= Backlight
4) Press numeric key 2 to set the level
in which the stable indication turns on (filtering).
The lower the setting, the faster stabilization time.
5) Press numeric key 3 to set the period
of inactivity before the scale automatically turns off.
Options are OFF(Non power-off)、 5、10、30 and
60 (minutes).
5) Press numeric key 4 to set the range in which the
zero indication turns on .Options are d0, d1, d2, d3,
d4 and d5. (d= scale division)
6) Press numeric key 5 to set serial transmission
rates. Options are 9600, 4800 and 2400.
7) Press numeric key 7 to set buzz sounds. Options
are Un，In，no，Lo and nbEEP.
=There will be a warning sound when the quantity of the articles exceeds upper limit.
=There will be a warning sound when the quantity of the articles is between the upper and
lower limit (including the upper and lower limits).
= There will be a warning sound when the quantity of the material exceeds the upper and
lower limits, and the weight of the material is more than 20 divisions.
To Next Page
Loading...
