Jands HP12 User Manual

[1]
DISPLAY = "Select channels for
60V"
[2]
[4]
[5]
[6]
[7]
DISPLAY = "Select chans for
Preheat off"
DISPLAY = "Select channels for
120V"
Status LED red = 60V or 120V
Status LED green = 240V
Status LED orange = Channel
selected for output voltage change
DISPLAY = "Select chans for
Linear-Power"
DISPLAY = "Select chans for
Switched Output"
DISPLAY = "Select chans for
Preheat on"
ENTER
ENTER
ENTER
ENTER ENTER
NORMAL
ENTER
ENTER
ENTER
ENTER
[2]
ENTER
[3]
ENTER
ENTER
ENTER ENTER
Voltage Temperature
Current core temperature
[Voltage choice for selected channel Voltage choice for selected channel
ENTER
ENTER
SELECT
STATUS
SELECT
STATUS
SELECT
STATUS
120V selection applied 240V selection applied
SELECT
STATUS
SELECT
STATUS
SELECT
STATUS
MODE
MODE
[START]
ENTER
ENTER
ENTER
Power Fault
Neutral detect "On"
ENTER
ENTER
Neutral detect "Off"
Neutral detect "On" selection applied Neutral detect "Off" selection applied
Law
Linear-Power Switched Output
[4]
[5]
Linear-Power selection applied Switched output selection applied
Preheat
Preheat "On"
Preheat "Off"
[6]
[7]
Preheat "On" selection applied Preheat "Off" selection applied
ENTER
SELECT
STATUS
Preheat "Level"
[8]
Preheat level set
ENTER
[9]
To "TERM"
[8]
DISPLAY = "Press select and hold
while changing channel preheat"
[9]
DISPLAY = "A"
(a letter between A and E)
ENTER
ENTER
[1]
Voltage choice for selected channel
60V selection applied
SELECT
STATUS
[3]
DISPLAY = "Select channels for
240V"
[Hold while
setting level]
MODE 1: VOLTAGE, TEMPERATURE, LAW, PREHEAT, VOLTAGE FLUCTUATION
(Termination, Check, Voltage Compensation & Lock to be continued next page)
Figure 4.1 A

Jands HP12 Specifications

General

Brand	Jands
Model	HP12
Category	Dimmer
Language	English