Jands HP12 User Manual

Dimmer Operation 4-8
Revision 2 - 20 March, 1997 HP SERIES DIMMER OPERATING MANUAL
• By pressing and HOLDING a channel SELECT button, and rotating the
encoder wheel, that channel level may be modified.
Note
The master level control no longer has any effect on the level of a modified
channel; ie. once a channel has been modified, it remains at that level while
still in RUN mode (regardless of the master level). The channel SELECT
button must pressed again to re-connect that channel to the master level
control.
• Once the SELECT button is released, the encoder wheel becomes the master
level control once more.
4.1.8.2 Scene
E Figure 4.4
If Scene 1(“SC1”) is selected, the display will scroll with the message “SC1 ON
LEVEL 100”.
• The overall output level may be altered with the LEVEL/FUNCTION
encoder wheel and the display will indicate a level between 100% and 0%.
• Pressing a channel SELECT button will isolate that channel from the master
level control. The STATUS LED will flash to show the channel is isolated.
Pressing the SELECT button again will re-connect the channel to the master
level control.
• By pressing and HOLDING a channel SELECT button, and rotating the
encoder wheel, that channel level may be modified.
Note
The master level control will no longer have any effect on the level of the
modified channel; ie. once a channel has been modified, it remains at that
level while still in RUN mode (regardless of the setting of the master level).
The channel SELECT button must pressed again to re-connect that channel
to the master level control.
• Once the SELECT button is released, the encoder wheel becomes the master
level control once more.
4.1.8.3 Preset chases
E Figure 4.4
If Preset Chase 4 (“PR4”) is selected, the display will scroll with the message
“PR4 RUN 100 b.P.M.”.
• The chase rate may be altered with the FUNCTION encoder wheel and the
display will indicate a rate between 6 and 600 beats per minute.
• By pressing and HOLDING a channel SELECT button, and rotating the
encoder wheel, that channel level may be edited.
• Once the SELECT button is released, the encoder wheel becomes the chase

Jands HP12 Specifications

General

Brand	Jands
Model	HP12
Category	Dimmer
Language	English