Jandy SFTM24-2.0 User Manual

H0579200_REVD
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and
qualified in pool equipment by the jurisdiction in which the product will be installed where such state
or local requirements exist. The maintainer must be a professional with sufficient experience in pool
equipment installation and maintenance so that all of the instructions in this manual can be followed
exactly. Improper installation and/or operation can create dangerous high pressure which can cause a
catastrophic product failure and/or cause the multiport valve to be blown off possibly causing death,
serious injury or property damage.
Before installing this product, read and follow all warning notices and instructions that accompany this
product. Failure to follow warning notices and instructions may result in death, serious injury or property
damage. Consult Zodiac customer service at 1-800-822-7933 for assistance. Improper installation and/or
operation will void the warranty.
ENGLISH | FRANÇES | ESPAÑOL
INSTALLATION AND
OPERATION MANUAL
Top Mount Sand Filter
Models SFTM22-1.5, SFTM24-2.0

Jandy SFTM24-2.0 Specifications

General

Brand	Jandy
Model	SFTM24-2.0
Category	Water Filtration Systems
Language	English

Summary

Section 1. Important Safety Instructions

General Safety Warnings and Precautions

Covers critical warnings about operating pressure, electrical hazards, and general cautions.

Section 3. Equipment Location

3.2 Filter Location

Section 4. Initial Setup

4.4 Fill With Sand

Instructions for adding filter sand, including important precautions.

4.5 Assemble Multiport Valve

Steps for assembling the multiport valve, including pressure gauge installation.

4.6 Install Multiport Valve

Instructions for securely mounting the multiport valve to the filter tank.

4.7 Plumbing

Section 5. Operation

5.1 Filter Valve Functions

5.2 Initial Start up

Detailed steps for the initial operation and startup of the sand filter.

5.3 Operating Pressure

Guidance on monitoring and setting the filter's operating pressure.

5.4 Changing the Filter Sand