janitza UMG 104 - Interfaces

51
UMG 104
Interfaces
The UMG104 has 4 serial interfaces:
- RS485
- RS232
- Profibus (optional)
All interfaces can be used simultaneously.
RS232
The following data must be programmed for
use of the RS232 interface:
- Baud rate,
- Operating mode.
Refer to the parameter list in the Appendix
for the default factory setting and the setting
ranges.
Addr. Content
200 Device address (1 .. 255)
valid for Modbus and Profibus
1 = default factory setting
RS485
The following data must be programmed for
use of the RS485 interface:
- Device address,
- Baud rate,
- Operating mode.
Refer to the parameter list in the Appendix
for the default factory setting and the setting
ranges.