To Next PageTo Next Page
Need help?Do you have a question about the janitza UMG 96RM-P and is the answer not in the manual?
General| Device type | Power Quality Analyzer |
|---|---|
| Mounting | Panel Mount |
| Measurement Category | CAT III |
| Power Measurement | Active, Reactive, Apparent Power |
| Frequency Measurement | 45-65 Hz |
| Communication Interfaces | RS-485, Ethernet |
| Current Measurement | 5 A |
| Energy Measurement | Active, Reactive Energy |
| Harmonic Analysis | Yes |
| Protocols | Modbus RTU |
| Display | LCD |
| Power Supply | 24...240 V AC/DC |
| Accuracy class | 0.5 |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20 to +70 °C |
| Dimensions | 96 x 96 mm |
Defines the intended application, installation guidelines, and proper usage for the device.
Details the general and specific features of the UMG 96RM-P/-CBM, including interfaces and measurements.
Provides guidance on physical installation, including location, position, and panel cutout dimensions.
Details the requirements and connection method for the device's power supply voltage.
Describes how to connect and configure the device for voltage measurements in various network types.
Details the connection and setup for current measurements using external current transformers.
Explains the RS485 interface, Modbus RTU protocol, and terminating resistor requirements.
Describes the USB interface for connecting to a computer and installing drivers.
Covers the Profibus DP V0 slave protocol, connection, and configuration for the UMG 96RM-P.
Explains how to operate the device using buttons, distinguishing between display and programming modes.
Describes how to access and configure device parameters and view measured values.
Details the initial configuration steps, including applying supply voltage and setting transformers.
