Service and maintenance
The device is subjected to several different safety tests
before leaving the factory and is labelled with a seal. If a
device is opened then the safety checks must be repea-
ted. Warranty claims will only be accepted if the device
is unopened.
Repair and calibration
Repair work and calibration can be carried out by the ma-
nufacturer only.
Front film
The front film can be cleaned with a soft cloth and stan-
dard household cleaning agent. Do not use acids and
products containing acid for cleaning.
Disposal
The UMG 96RM-P/-CBM can be reused or recycled
as electronic scrap in accordance with the legal provi-
sions. The permanently installed lithium battery must
be disposed of separately.
Service
Should questions arise, which are not described
in this manual, please contact the manufacturer directly.
We will need the following information from you to an-
swer any questions:
- Device name (see rating plate),
- Serial number (see rating plate),
- Software release (see measured value display),
- Measuring-circuit voltage and power supply voltage,
- Precise description of the error.
Device calibration
The devices are calibrated by the manufacturer
at the factory - it is not necessary to recalibrate the de-
vice providing that the environmental conditions are
complied with.
Calibration intervals
It is recommended to have a new calibration carried out
by the manufacturer or an accredited laboratory every
5 years approximately.
To Next Page
Loading...
