Janome 6234XL - Adjustment of Needle Plate Setting Knob

(A)
(B)
1
5
Adjustment of Needle Plate Setting Knob
(Changing to Standard
Serging or Rolled
Hemming)
1. Turn off the power switch and unplug the
machine.
2. Open the looper cover and side cover.
3. Disengage the upper knife. (Refer to page 11)
4. Push the cutting width adjusting
dial to the right
as far as it
will go, then, move the needle plate
setting knob to the guide line of S (for Standard
Serging) or R {for Rolled Hemming).
Release the cutting width adjusting dial to the left
gently.
5. Set the upper knife to up position.
6. Close the looper cover and side cover.
G) Chaining finger
®Guideline
® Cutting width adjusting dial
@ Upper knife
® Needle plate setting knob
(A) Standard Serging
• The chaining finger is located beside the needle plate
as shown in diagram (A) for guiding the flat edge of the
fabric for
overlock sewing.
(8) Rolled Hemming
• Pull the needle plate setting knob from "S" to "R"
position, so that the fabric edge will be rolled for
hemming, picot edging and narrow hemming.
13