Janome 6260QC - Basic Zigzag Stitch; Adjusting the Stitch Width; Adjusting the Stitch Length

01)
7-segment LED
02)
Mode LED
03)
Button
04)
Bobbin winder
switch
05)
Not applicable to
this model
06)
Buttonhole Sensor
#
01 16 31 46
Sensor
#
01 16 31 46
Sensor
Defective ConditionCorrect ConditionProcedure
Step and items
to check
Turn on the power switch while
simultaneously pressing the
needle up/down button and the
reverse button. Press the reverse
button five times to select menu
item “6”. Press the needle up/
down button: the LED indicates
“01” for one second. If you don’t
press the reverse button within
2.5 seconds, the machine
automatically reverts to normal
sewing mode.
Beep sounds when the
button is pressed.
LED displays “8.8.” And it
blinks in one second
Intervals.
No beep sound
Does not enter self-diagnostic
mode.
LED does not blink on or off.
1. Replace A-board.
LED
Press needle up/down button,
LED displays “02” for one
second.
7-segment LED displays
“Ld” and 3 mode LEDs
blink in one second
intervals.
LED does not blink on or off.
1. Replace A-board.
LED displays
Button number is displayed
when the button is pressed
LED display is different from
that shown to the left.
1. Replace A-board.
Button
Button
S1
S2
S3
S4
S5 S6 S7 S8S1
S8
Press needle up/down button,
LED displays “04” for one
second.
Move the bobbin winder spindle
to the right.
Return it to the left.
LED displays “II”.
(Left)
(Right)
LED display is different from
that shown to the left.
1. Adjust bobbin winder switch
position.
2. Replace bobbin winder
switch.
3. Replace A-board.
21
LED display is different from
that shown to the left.
1. Adjust buttonhole sensor
position
2. Replace buttonhole sensor.
3. Replace A-board.
Skip this step by pressing the
needle up/down button
Press needle up/down button,
LED displays “06” for one
second.
Lower the buttonhole lever.
Move the buttonhole lever back
and forth.
When the buttonhole lever
is pulled, LED displays “H”.
When the buttonhole lever
is free (positioned in the
center), LED displays “L”.
When the buttonhole lever
is pushed, LED displays
“H”.
Press needle up/down button,
LED displays ”03” for one
second.
Press buttons S1 to S8.