Janome AT2000D - Threading the Lower Looper

19
NOTE:
Raise the presser foot lifter for easier threading.
z Draw the thread through the right side thread guide
from back to front: (A)
q Thread guide
Threading the Lower Looper
CAUTION
Turn the power switch OFF before threading the
machine.
z
x
c
v
b
(A)
(B)
q
w
y
u
e
r
r
t
z
x
c
v
b
x Slide the thread under the top cover thread guide as
illustrated.
w Top cover thread guide
c Pull the thread along the slit.
Using both hands, insert the thread between the
tension disks of the lower looper thread tension dial.
e Thread
r Tension disk
t Lower looper thread tension dial
v Set the lower looper pre-tension setting slider to STD.
y Lower looper pre-tension setting slider
b Draw the thread along the slit and pass it through the
right slit of the looper thread guide.
u Right slit of looper thread guide
NOTE:
If the thread tends to slip away from the guide while
sewing, pass the thread through both thread guide
holes as shown: (B)